Table of Contents
Advertisement
Steps
1. Identify the designated location for the system controller in the rack.
● The designated location for a single node, or the primary node of an HA pair with ES30 shelves is U13-16 in rack 1.
● The designated location for the standby node of an HA pair with ES30 shelves is U18-21 in rack 1 (single rack) or U13-16
in rack 2 (multiple racks).
● The designated location for a single node with DS60 shelves is U23-26 in rack 1.
● The designated location for the primary node of an HA pair with DS60 shelves is U22-25 in rack 1.
● The designated location for the standby node of an HA pair with DS60 shelves is U27-30 in rack 1.
NOTE:
The designated slots in the rack are the recommended location for the DD9500 system to support the cabling
described in this document. Other locations may require different cable lengths for some configurations.
2. From the front of the rack, lift the DD9500 system using the handles supplied for lifting to install the system in the rack in
the correct location.
3. At each side, align the bottom of the chassis with the lip of each installed rack bracket.
4. Carefully slide the chassis into the rack and remove the back handles while supporting the chassis weight. Continue to slide
the rest of the chassis and remove the front handles. Finally, push the chassis all the way into the back of the rack.
5. The rear of the chassis should engage with the tabs located in the rear of the rack mount kit.
6. At the front, attach the system to each installed bracket using the screws on the front of the system. The screws are shown
in red circles in the photo.
NOTE:
On each side of the chassis, a bezel bracket sits between the upper and lower screws that secure the chassis
to the rack. The bezel brackets are marked with left and right to denote which side of the chassis to install them on.
However, the brackets for each side are not physically different. Inverting the bracket allows it to be used on the other
side of the chassis.
Figure 15. System on a rack
20
Install the System in the Rack
Advertisement
Table of Contents
