Drive Carrier Leds; Power Supply Leds - Bosch DIVAR IP 6000 Series Installation Manual

16 en | System overview
–
–
–
–
3.3.3

Drive carrier LEDs

ActivityLED
StatusLED
3.3.4

Power supply LEDs

On the rear of the power supply module, an LED displays the status.
–
–
2016.08 | V2.1 | DOC
When continuously on (not flashing) the LED indicates an overheat condition, which may
be caused by cables obstructing the airflow in the system or the ambient room
temperature being too warm. Check the routing of the cables and make sure all fans are
present and operating normally. You should also check to make sure that the chassis
covers are installed. Finally, verify that the heat sinks are installed properly.
This LED will remain flashing or on as long as the fan failure/overheat condition exists.
NiC2: A flashing LED indicates network activity on GLAN2.
NIC1: A flashing LED indicates network activity on GLAN1.
HDD: A flashing LED indicates IDE channel activity in the SAS/SATA drive, SCSI
drive, and/or DVD-ROM drive activity.
Power: Indicates power is being supplied to the system's power supply units.
This LED should normally be illuminated when the system is operating.
LED color
Blue
Blue
Red
Red
Red
Red
Red
Solid Green: When illuminated, indicates that the power supply is on.
Solid Amber: When illuminated, indicates the power supply is plugged in and turned off,
or the system is off but in an abnormal state.
Blinking pattern
Solid On
Blinking
Solid On
Blinking at 1 Hz
Blinking with two
blinks and one stop
at 1 Hz
On for five seconds,
then off
Blinking at 4 Hz
Installation Manual
DIVAR IP 6000 (3U)
Behavior for device
SAS drive installed
I/O activity
Failed drive for SATA/NVMe with
RSTe support
Rebuild drive for SATA with RSTe
support
Hot spare for SATA with RSTe
support
Power on for SATA with RSTe
support
Identify drive for SATA with RSTe
support
Bosch Sicherheitssysteme GmbH