Table of Contents
Advertisement
Transporting the
Demand Duo™
•
Choose the right hand truck to support the weight
and size of the water heater. Refer to the
Specifications section in this manual for specific
weights and dimensions.
•
Use proper lifting techniques to load the water
heater onto the hand truck:
−
Position the water heater onto the hand truck
so the weight is evenly balanced and the tank is
touching the rails of the hand truck.
−
Secure the water heater to the hand truck:
→
Position STRAP A around the tankless unit
as illustrated below.
→
Position STRAP B around the base of the
tank below the lower enclosure.
Strap A
Lower
Enclosure
Strap B
Rinnai Commercial Hybrid System Installation and Operation Manual
Earthquake Strapping
Instructions
NOTICE
Products installed in the state of California must be
braced, anchored, or otherwise secured to avoid
motion or falling during an earthquake. Contact the
California Office of the State Architect located at 1102
Q Street, Suite 5100, Sacramento, CA 95811 for
instructions.
1. Loosen the screws along the perimeter of the plastic
enclosures.
2. Remove the plastic enclosures.
3. Position straps around the tank per the requirements
of California Office of the State Architect. DO NOT
POSITION THE STRAPS OVER PIPE, FITTINGS or
WIRE.
4. Replace the plastic enclosures. Modification of the
plastic enclosures may be necessary to fit the
enclosures over the earthquake straps.
5. Replace the screws around the perimeter of the
plastic enclosures.
Plastic
Enclosure
(Side)
Plastic
Enclosure
(Bottom)
STRAP
STRAP
13
Advertisement
Table of Contents
