Table of Contents
Advertisement
Auto Dry Function
1
Auto dry function can be setted/released
by manipulating indoor unit button or
remote control.
2
When pressing the
the function, evaporator in indoor unit will
be automatically dried as showing counting
00 to 99 on its display panel.
3
After indicating 99 on the display panel,
the unit will be automatically turned off.
* Auto dry function is released at initial
state as standard.
For Setting Auto Dry Function
If manipulating indoor unit, press the
button and
button simultaneously for 3
MODE
seconds.
If manipulating remote control for Cooling
Only model, press
The indoor unit will respond with beep once
and indicate "SC" on its display panel. Then
Auto dry function will be set.
For Releasing Auto Dry Function
If manipulating indoor unit, press the
button and
button simultaneously for 3
MODE
seconds.
If manipulating remote control, press
button.
The indoor unit will respond with beep twice
and Auto dry function will be removed.
<TYPE A>
MODE
<TYPE B>
button after setting
button.
OPERATING INSTRUCTIONS
Auto Restart Operation
When power is supplied again after unit
operation has been stopped because of
interruption of power supply due to outage or
other causes, auto re-operation will be
performed by remembering previous setting.
- When power is supplied, outdoor unit
operation will be started within 3 minutes.
1
Auto Restart Operation can be
established/released by manipulating
indoor unit button.
* When initial state, Auto Restart
Operation will be set up as standard.
For Releasing Restart Operation
Press the
,
,
simultaneously for 3 seconds.
The unit will respond with beep and Restart
Operation will be removed.
For Setting Restart Operation
After function release, Press the
g
or
(4 buttons) simultaneously for 3
seconds.
The unit will respond with beep and restart
operation will be setted.
<TYPE A>
MODE
<TYPE B>
17
g
,
or
(4 buttons)
,
,
,
Advertisement
Table of Contents
