Table of Contents
Advertisement
OPERATING INSTRUCTIONS
16
Defrost Mode
Heat Pump
1
During defrost operation,
cated at display section of indoor.
MODE
2
During heating operation, if outside tem-
perature is low and humidity is high, heat-
ing capability will be deteriorated as frost is
generated at outdoor unit, therefore, the
frost will be removed by performing de-
frost operation.
3
When indoor and outdoor unit fans are au-
tomatically stopped and defrost operation
is completed, preheating for heating cycle
will automatically be started.
* Heating operation will be started in a lit-
tle time.
!
NOTE
What is preheating function for heating cycle?
• During the heating, indoor fan will not be oper-
ated until indoor tubing temperature becomes
more than 22 °C, therefore, this is the function
to block the discharge of cold wind.
• During the preheating for heating cycle, heat-
ing cannot be performed.
• During defrost operation, vapor can be gener-
ated at outdoor side, and this is not a failure
because it is the operation to remove frost.
Child Lock Operation Function
1
Press the
and high
for 3 seconds. Or press the
remote control.
2
During child lock operation,
- Whenever you press any button on dis-
play panel, it will immediately display
"CL", which means display panel is
locked.
- All the button on the indoor unit display
panel will not work.
- But the button on the remote controller
will be operated.
3
M
will be indi-
Auto Dry Function
1
2
3
If manipulating indoor unit, press the
button and
seconds.
If manipulating remote control for Cooling
Only model, press
The indoor unit will respond with beep once
and indicate "SC" on its display panel. Then
Auto dry function will be set.
If manipulating indoor unit, press the
button and
seconds.
simultaneously
If manipulating remote control for Cooling
X
button on
Only model, press
The indoor unit will respond with beep twice
and Auto dry function will be removed.
Press the
and high
for 3 seconds again. The unit will respond
with beep. child lock operation will re-
moved
MODE
Auto dry function can be setted/released
by manipulating indoor unit button or re-
mote control.
When pressing the
the function, evaporator in indoor unit will
be automatically dried as showing counting
00 to 99 on its display panel .
After indicating 99 on the display panel,
the unit will be automatically turned off.
* Auto dry function is released at initial
state as standard.
For Setting Auto Dry Function
button simultaneously for 3
MODE
button.
For Releasing Auto Dry Function
button simultaneously for 3
MODE
button.
MODE
simultaneously
button after setting
Advertisement
Table of Contents
