Care And Cleaning - Kohler K-6300 Installation And Care Manual

Complete the Installation (cont.)
Clean the vitreous surface where the side panel adhesive locking
tape will contact the bowl.
Make sure the vitreous surface is dry.
Determine the correct panel for each side of the bowl.
Peel the backing off each of the three strips of adhesive locking
tape on one of the side panels.
Carefully align the side panel and press into place.
Repeat for the second side panel.
IMPORTANT! Do not remove the side panels for at least 24 hours
after installation them. This will allow the adhesive to fully adhere
to the vitreous surface.

Care and Cleaning

WARNING: Risk of property or product damage. Do not
use in-tank cleaners in your toilet. Products containing
chlorine (calcium hypochlorite) can seriously damage fittings
in the tank. This damage can cause leakage and property
damage.
Kohler Co. shall not be responsible or liable for any tank fitting
damage caused by the use of cleaners containing chlorine (calcium
hypochlorite).
For best results, keep the following in mind when caring for your
KOHLER product:
• Always test your cleaning solution on an inconspicuous area
before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately
after applying cleaner. Rinse and dry any overspray that lands on
nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive
material such as a brush or scouring pad to clean surfaces.
1145594-2-B 14 Kohler Co.