Denon PMA-600NE Owner's Manual page 30

Contents Connections
o Reconnecting to this unit from a Bluetooth
device
After pairing is completed, the Bluetooth device can be connected
without performing any operations on this unit.
This operation also needs to be performed when switching the
Bluetooth device for playback.
1
If a Bluetooth device is currently connected, deactivate
the Bluetooth setting of that device to disconnect it.
2
Activate the Bluetooth setting of the Bluetooth device
to be connected.
3
Select this unit from the Bluetooth device list on your
Bluetooth device.
4
Play music using any app on your Bluetooth device.
0 When the power of this unit is turned on and analog mode is off, the input source
will be automatically switched to "BLUETOOTH" if a Bluetooth device is
connected.
0 When a Bluetooth device is connected with the unit while on Bluetooth standby
state (while the power indicator is lit in red), the power of the unit will be turned on
automatically. To enable Bluetooth standby, set this unit to standby when analog
mode is off. (v p. 27)
Front panel Rear panel
Playback Settings
Connecting and playing back from a
digital device (Coaxial/Optical)
1
2
3
0 The DIGITAL IN/BLUETOOTH indicator blinks in green when audio signals that
are not supported by this unit are input.
0 If the sampling frequency cannot be detected, the DIGITAL IN/BLUETOOTH
indicator turns off.
Remote control 30
unit
Tips
Connect digital device to this unit. (v p. 21)
Press the input source select button (COAXIAL,
OPTICAL 1 or OPTICAL 2) to switch the input source to
"COAXIAL", "OPTICAL 1" or "OPTICAL 2".
The indicator of the selected input source lights.
Start playback of the digital device connected to this
unit.
The DIGITAL IN/BLUETOOTH indicator lights in green.
Index
Appendix