Denon PMA-600NE Owner's Manual page 19

Contents Connections
Connecting a playback device
You can connect turntables, CD players, network audio players and Blu-ray Disc players to this unit.
If you set this unit's input source to "PHONO" and you accidentally increase the volume without having a turntable connected, you may hear a hum noise
from the speakers.
CD player
AUDIO
OUT
Turntable
R L
R L
R L
AUDIO
GND
OUT
L
R
Front panel Rear panel
Playback
Blu-ray Disc
Network audio
player
player
AUDIO AUDIO
OUT OUT
R L R L
R L R L
R L R L
Remote control
unit
Settings
NOTE
0 The earth terminal (SIGNAL GND) of this unit is not for safety
grounding purposes. If this terminal is connected when there is a
lot of noise, the noise can be reduced. Note that depending on
the turntable, connecting the ground line may have the reverse
effect of increasing noise. In this case, it is not necessary to
connect the ground line.
0 The PHONO input terminals are equipped with a short pin-plug.
Remove this plug to connect a record player. Store the removed
short pin-plug in a safe place so as not to lose it.
19
Index
Tips Appendix