Advanced Menu; Security Menu - HP Pavilion N3110 Using Instructions

Quiet Boot When enabled, hides summary of
power-on self-test and messages during boot.
System Memory Shows the system memory size.
Extended Memory Shows the extended memory size.

Advanced Menu

Serial port Sets how the serial port is configured by the
BIOS (specified or automatic).
Base I/O address Sets the I/O address and interrupt.
IrDA port Sets how the infrared port is configured by the
BIOS (specified or automatic).
Mode When IrDA port is enabled, sets the hardware to
support SIR (Standard IR) or FIR (Fast IR) infrared
communications. (Driver installation is required.)
Base I/O address When IrDA port is enabled, sets the I/O address
and interrupt.
DMA channel When Fast IR mode is enabled, sets the DMA
channel.
Parallel Port Sets how the parallel port is configured by the
BIOS (specified or automatic).
Mode Sets the port to output only, bi-directional, ECP
mode, or EPP mode.
Base I/O address Sets the I/O address.
DMA channel When ECP mode is enabled, sets the DMA
channel.
Local Bus IDE Adapter Enables the primary (hard drive) and secondary
(CD-ROM drive) controllers.
Floppy disk controller Enables the floppy disk drive.

Security Menu

User Password Is Shows if a user password is set.
Supervisor Password Is Shows if a supervisor password is set.
Set User Password Press ENTER to set, change, or clear user
password. Password length can be no longer
than 8 characters, 0-9, A-Z.
Set Supervisor Press ENTER to set, change, or clear supervisor
Password password. This password protects BIOS Setup
settings.
Password on boot Sets whether a user password is required when
the computer boots.
Power (APM)
Menu*
PM Control Disables power management, or enables it
Enabled
640KB
Detected
automatically.
Default
Enabled
3F8 IRQ4
Disabled
SIR
2F8 IRQ3
DMA 3
Enabled
Bi-directional
378 IRQ7
DMA 0
Both
Enabled
Default
Clear
Clear
Enabled
Default
Battery Powered
3