Table of Contents
Advertisement
5.
Turn the display assembly upside down, with the bottom toward you.
6.
Lift and release the bottom of the display enclosure (1).
7.
Disconnect the display logo cable (2) from the display panel cable.
8.
Route the webcam cable and antenna cables (3) through the hinge channel.
9.
Remove the display enclosure (4). The display enclosure is available using spare part number
605330-001.
10.
If it is necessary to remove the hinge cover, remove the four Phillips PM2.5×5.0 screws (1) that
secure the hinge cover to the display assembly, and then remove the cover (2). The hinge cover is
available using spare part number 605336-001.
11.
If it is necessary to replace the webcam/microphone module, remove the Phillips PM2.0×4.0
screw (1) that secures the module to the display bezel.
12.
Release the webcam/microphone module (2) as far as the webcam/microphone module cable
allows.
70
Chapter 4 Removal and replacement procedures
Hide quick links:
Advertisement
Table of Contents
