HP Pavilion DM1z-3000 Maintenance And Service Manual page 61

4. Remove the wireless antenna cables from the clips (2) and routing channel built into the base
enclosure.
CAUTION:
support the display assembly can result in damage to the display assembly and other computer
components.
5. Remove the 4 screws (1) that secure the display assembly to the base enclosure.
6. Slide the display panel cable (2) back toward the display assembly while lifting the display
assembly (3) straight up to remove it.
7. Lift the display assembly (3) straight up and remove it.
8. If it is necessary to replace the display bezel or any of the display assembly internal
components:
a. Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge
(3) of the display bezel until the bezel disengages from the display enclosure.
ENWW
Support the display assembly when removing the following screws. Failure to
Component replacement procedures 53