General Setup; Format Settings; Setting The Clock Display; Setting The Time - Alpine HALO9 iLX-F309TC Quick Reference Manual

General Setup

[General] is selected on the General Setup Menu screen in step 1. See
"General Setup" (page 29).
You can set up items related to the clock, etc.

Format settings

The character code to be used for tag text information displayed on the
screen can be selected from 7 character codes.
Setting item:
Format
Setting contents:
Latin-1 / Latin-9 (Initial setting) / Russian / Chinese / Thai / Arabic / Hebrew
Latin-1: ISO 8859-1
Latin-9: ISO 8859-15
Russian: ISO 8859-5
Chinese: GB18030-2005
Thai: CP874
Arabic: CP1256
Hebrew: CP1255

Setting the Clock Display

You can select the clock display type, 12-hour or 24-hour, depending on
your preference.
Setting item:
Clock Mode
Setting contents:
12H (Initial setting) / 24H

Setting the Time

Setting item:
Time Adjust
Additional items:
Hour / Minute
Setting content:
AM12 - PM12 or 0-23 / 0-59
Hour: Adjust the hour.
Minute: Adjust the minute.
• Cannot be adjusted while no GPS signal is received.

Setting Daylight Saving Time

Setting item:
Daylight Saving
Setting contents:
Off (Initial setting) / On
Off: Return to the ordinary time.
On: Place the Summer Time mode ON. The time advances by
one hour.
38
-EN

About iLX-F309

[About] enables you to check the Serial No., Firmware Version, Model
Name, and to initialize various settings.
Displaying the Product Information
You can view the version information of this product. Make note of this
information and refer to it whenever you contact Alpine Tech Support
or an Alpine-authorized dealer.
Setting contents:
Serial No. / Firmware Version / Model Name
Initializing the System
You can initialize all data, to restore the factory settings. Remove the
USB flash drive, etc. from the system before operation
Setting item:
Clear All Settings
1
Touch [Reset] of "Clear All Settings."
2
After the confirmation message appears, touch [OK].
The confirmation screen appears again.
3
Touch [OK].
The system starts initialization.
• Do not turn on/off the power, change the ignition key position or
remove the screen panel until system restart is completed.

Setting Demo mode to Off/On

This unit has a Demonstration feature for the display. When you install
and use the unit for the first time, the unit will enter demo mode
automatically. To quit demo mode, set Demo mode to Off.
Setting item:
Demo mode
Setting contents:
Off (Initial setting) / On
• If you perform an operation during the Demo mode, the demonstration
is temporarily stopped.