HP OmniBook 2000 User Manual page 26

For information about compatible cards, visit our Web site at
http://www.hp.com/go/omnibook. Or contact Hewlett-Packard as described in the
Support and Service booklet.
Caution
Do not install Card Services or Socket Services software if it comes with your
PC card. The OmniBook already includes Card Services and Socket Services,
which automatically detect and set up PC cards you install in the upper and
lower card slots. Different versions of this software will disrupt this support.
Never insert or remove a plug-in card while an OmniBook PC card drive is
actively reading or writing data. Wait until the PC card drive is done.
Otherwise, you could lose data or the OmniBook could stop responding.
The OmniBook automatically detects and sets up a card when you insert it in a card
slot. See the card's instructions for additional information.
1. Hold the card with its face up and its connector holes toward the card slot, then
slide it into a PC card slot until it won't go any further.
When the card is fully inserted, the PC card indicator appears on
the Status Panel. A double beep signals that the card has been
recognized and is successfully configured by your computer.
2. Inserting a card causes the slot's eject button to protrude from the case. You can
rotate the button towards the front to make it flush with the case.
About RAM Cards
Start popup
About RAM Cards
If you're using a RAM card with the OmniBook, keep these suggestions in mind:
For a new RAM card, install its battery before you insert the card.
Replace the RAM card battery yearly.
When you want to replace a RAM card battery, plug the card into the OmniBook
and make sure the OmniBook stays turned on while you replace the battery. You
can plug in the ac adapter to keep it from turning off. Otherwise, the data on the
card will be lost.
End popup
26