Connection - Tripp Lite AGSM5000Y3U3I Owner's Manual

Connection

1
Connect a charged external battery pack to your UPS.
Your UPS has no internal batteries and must be connected to an external battery pack to
operate. Complete installation and mounting instructions for your battery pack appear in the
battery pack's Owner's Manual. Make sure that cables are fully inserted into their connectors.
Small sparks may result during battery connection; this is normal. Your UPS will not start unless
connected to a charged external battery pack.
Note: UPS system will function properly upon initial startup; however, maximum runtime for the
unit's battery will only be accessible after it has been charged for 24 hours.
2
Set the double-pole input breaker to the "ON" position (towards
the left side of the rear panel).
3
Plug your UPS line cord into an electrical outlet.
Once your UPS is plugged in, the UPS will enter STANDBY mode. The fan will activate and
the " " LED will begin flashing. The UPS system's outlets will not be active until the UPS
is turned ON.
Your UPS features a 30-amp plug. However, a trained technician may replace this plug with a
user-supplied 50-amp plug. This will alter the UPS capabilities. See Specifications for more
information.
4
Plug your equipment into your UPS.
Your UPS is designed to support only computer equipment. You will overload your UPS if you
connect household appliances, laser printers or surge protectors to the UPS outlets.
5
Turn your UPS ON.
• Press the "POWER" button
• Hold the button for a moment, until the "
• Release the button
Your UPS is now ON and its AC outlets are active.
" LED stops flashing and illuminates constantly
4
1
2
3 NEMA L6-30P plug shown
4
5