Table of Contents
Advertisement
Fan/heat sink assembly
Description
Fan/heat sink assembly (includes replacement thermal material) for use only with computer
models with UMA graphics subsystem memory
Fan/heat sink assembly (includes replacement thermal material) for use only with computer
models with discrete graphics subsystem memory
Thermal pad
Before removing the fan/heat sink assembly:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn on
the computer, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first disconnecting the power cord from the AC
outlet and then disconnecting the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Top cover (see
e.
Speaker assembly (see
f.
Display assembly (see
g.
System board (see
Remove the fan/heat assembly (fan/heat sink appearance might vary):
NOTE:
Steps 1 through 4 apply only to computer models equipped with graphics subsystems
having UMA memory.
1.
Turn the system board right-side up, with the front toward you.
ENWW
Battery on page
42).
Hard drive on page
43)
Optical drive on page
Keyboard on page
54)
Top cover on page
57)
Speaker assembly on page
Display assembly on page
System board on page
46)
60)
69)
75)
Component replacement procedures
Spare part number
606013-001
606014-001
634363-001
79
Advertisement
Table of Contents
