RIDGID R4010TR Operator's Manual page 17

ASSEMBLY
TO CLOSE / OPEN THE WSUV™ WET SAW
UTILITY VEHICLE / LEG STAND
See Figures 16 - 18.
 Remove water tray, water tray extensions and the water
tank, and any workpieces from the tool. Store.
 Place the sliding table in the center of the frame and lock
the table in place.
 Lower the wheel and secure by locking the saw head in
place using the lock knob.
To close the leg stand:
 At the same time, step on the release lever, grasp the
grips, and lift the handles up and away from the body.
 Push the saw until the release lever clicks and locks into
place.
To move the leg stand:
 Holding the grips firmly, pull the handles toward you until
the leg stand and saw are balanced on the wheels.
 Push the saw to the desired location then either open
the leg stand for saw operation or store the saw in a dry
environment.
To open the leg stand:
 Step on the release lever and pull the grips toward you
at the same time.
 Once the leg stand is released from the release lever,
ease the leg stand toward the floor by pushing the grips
toward the floor.
 With your hands on the grips, push the leg stand towards
the ground until the saw is in an open position.
NOTE: The release lever will close over the center brace
locking the leg stand in an open position.
Garden
hose
Garden
hose
connector
Fig. 15
17 — English
release
leVer
Fig. 16
Fig. 17