Advertisement
before you call
Problem
Self Clean does not work or is performing poorly
Soil not completely removed after self clean.
Self Clean Problems
Questions or for service call: 1-877-4 ELECTROLUX (1-877-435-3287)
Solution
Review steps for
"Read Before Starting Self Clean:"
page
33.
Perform the following check: Press Broil; Press START. Place your
hand near the handle on the oven door. Between the door and the
control panel you should feel a rush of air on your hand. If so, your unit
is functioning properly and you have had a Power Failure in your home.
If no air stream is present, call a service technician to replace your
cooling fan.
Self clean was interrupted. Review instructions on
page
33.
Excessive spills on oven bottom. Remove excessive spills before
starting self clean.
Failure to clean soil from the oven frame, the door liner outside the oven
door gasket, and the small area at the front center of the oven bottom.
These areas are not in the self-cleaning area, but get hot enough to
burn on residue. Clean these areas before starting the self-cleaning
cycle. Burned-on residue can be cleaned with a stiff nylon brush and
water or a nylon scrubber. Be careful not to damage the oven gasket.
43
beginning on
"Self
Clean"on
Advertisement
