Table of Contents
Advertisement
Getting through narrow
spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord
is unplugged from the wall outlet.
2 Open the freezer drawer and remove
the toe grille (see "Installation" section).
3 Remove any food from the door
shelves and close the doors.
To remove the refrigerator doors:
1 Trace lightly around the door's top
hinges with a pencil. This makes
reinstallation easier.
Front
Cover Screw
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
2 Disconnect the harness by grasping
both sides of the connector firmly,
depress the latch, and pull apart.
Remove the two screws from the top
hinge. Lift the door off of the bottom
hinge and set it aside.
Removing the Doors
3 Unscrew the three lower hinge
screws and hinge if necessary.
To reinstall the right door, reverse the
above steps.
Once both doors are in place, ensure
they are aligned with each other and level
(please see the "Installation" section for
more details), and replace the top hinge
cover.
Rear
Cover
Screw
Be sure doors are set aside in a secure
position where they cannot fall and
cause personal injury, or damage to the
Ground
doors or handles.
Screw
Top
Hinge
Drawer is heavy. Use caution when
lifting.
Lower Hinge Removal
CAUTION
CAUTION
11
Advertisement
Table of Contents
