Operation; Installation Check List Before Operation; Using The Temperature Control Panel - EdgeStar IWR600DZ Owner's Manual

NOTE: The temperature set
for the LOWER temperature
zone must always be just as
high or higher than that in
the UPPER temperature
zone. For optimal
performance, the set
temperature of the two
zones should differ by at
least 4°C.
Note: Whether your wine
cooler can reach the actual
set temperature depends on
the ambient environmental
conditions.
Caution: If you powered off
the unit, please wait at least
5 minutes before powering it
back on.
7

OPERATION

Installation Check List before Operation

1. Have all packing materials and tape been removed from the interior
and exterior of the wine cooler?
2. Have the installation instructions been followed, including connecting
the machine to electricity? And has proper grounding been installed for
the wine cooler?
3. Has the machine been leveled?
4. Is the wine cooler in a site where the ambient temperature is between
50º F and 90º F all year round?

Using the Temperature Control Panel

Upper Zone
Upper Zone Current Temperature
Temperature
Controls
Power Button
Press and hold the power button
turn the unit's power on or off.
Use the up and down buttons to adjust the temperature. The temperature
displayed can be in Fahrenheit or Celsius. This wine cooler has a
temperature range from 41°F to 72°F.
The unit will display Celsius or Fahrenheit depending on what scale
temperature the user prefers. To switch between C and F, press and hold
the button for approximately 5 seconds until the temperature scale
changes.
Note: Pressing the power button once can switch off the audible alarm
when the alarm is on.
This wine cooler has a Current Temperature Display that shows the
internal temperature of the unit. When the unit is turned on for the first
time, the cooler will automatically cool to 54˚F.
Press the
1 degree increments. The display will flash the Set Temperature while
user makes the setting.
Press the
by 1 degree increments.
Allow at least 24 hours before storing your wines and to allow the
temperature to acclimate.
Press the
Lower Zone Current Temperature
button on the control panel to lower the temperature by
button on the control panel to increase the temperature
button to turn the inner light on or off.
Lower Zone
Temperature
Controls
for approximately 5 seconds to
Light Button