Fully Integrated Built-In Installation - EdgeStar IWR600DZ Owner's Manual

Important Notes:
• Choose a location that has
ambient temperatures
above 50°F and below
90°F. Operation outside
these temperatures may
result in lowered efficiency
or cause other adverse
effects.
• This unit MUST be
installed in an area
protected from the
elements, e.g., wind, rain,
water spray or drips.
• The wine refrigerator
should not be located next
to ovens, grills or other high
heat sources.
• Do not kink or pinch the
power supply cord between
the wine refrigerator and
wall or cabinet.
• Make sure that the socket
and ON/OFF switch are
easily accessible after the
appliance has been
installed.
Caution: If you powered
off the unit, please wait
at least 5 minutes
before powering it back
on.
3

Fully Integrated Built-In Installation

The wine cellar door has a protruding lip that will almost completely seal
the installed unit, so it is very important that an air vent is provided in the
base of the housing.
A B
34.29" 34.84"
Installation Instructions:
1. Wipe the interior and exterior of the unit down with a damp,
lukewarm cloth.
2. Place the built-in unit into the recessed cabinet space.
3. Secure the unit to the upper cabinet by placing the fixing
bracket on top of the unit and inserting the 2 provided screws.
4. Next, take the 2 side gaskets to seal the gaps between the unit
and the cabinet on either side.
5. To install the handle, follow the directions in the section labeled
Installing the Door Handle.
6. Make sure the unit is level by following the instruction in the
section labeled Leveling the Wine Cooler.
7. Plug the unit in to a grounded 3-pronged outlet. This outlet
should be easily accessible and exclusive to the unit.
Note: Whether your wine cooler can reach the actual set temperature
depends on the ambient environmental conditions.
C
34.57"