Using The Sleep Timer - Yamaha R-N803 D Owner's Manual

Playback
■
Adjusting the LOUDNESS control
DIMMER DISPLAY MODE
INPUT BASS
PHONES SPEAKERS USB
A B
5V 1A
YPAO MIC
Retain a full tonal range at any volume level, thus
compensating for the human ears' loss of sensitivity to
high and low-frequency ranges at low volume.
Note
The LOUDNESS control does not function when the YPAO
Volume function (p. 50) is enabled.
CAUTION
If the PURE DIRECT switch is turned on with the LOUDNESS
control set at a certain level, the input signals bypass the
LOUDNESS control, resulting in a sudden increase in the sound
output level. To prevent your ears or the speakers from being
damaged, be sure to press the PURE DIRECT switch after
lowering the sound output level or after checking that the
LOUDNESS control is properly set.
1
Set the LOUDNESS control to the FLAT
position.
2
Rotate the VOLUME control on the front
panel (or press VOLUME +/– on the remote
control) to set the sound output level to the
loudest listening level that you would listen
to.
3
Rotate the LOUDNESS control until the
desired volume is obtained.
Note
After setting the LOUDNESS control, enjoy listening to music at
your preferred volume level. If the effect of the LOUDNESS
control setting is too strong or weak, readjust the LOUDNESS
control.
24
En
PURE DIRECT
MEMORY CLEAR BAND PRESET TUNING
VOLUME
TREBLE BALANCE LOUDNESS SELECT
PUSH - ENTER
FLAT
-30dB
RETURN
CONNECT
L R
LOUDNESS VOLUME

Using the sleep timer

Use this feature to automatically set this unit to standby
mode after a certain amount of time. The sleep timer is
useful when you are going to sleep while this unit is
playing or recording a source.
A
PHONO
COAX 1 COAX 2
OPT 1
LINE 1
Note
The sleep timer can only be set with the remote control.
1
Press SLEEP repeatedly to set the amount of
time before this unit is set to standby mode.
Each time you press SLEEP, the front display
changes as shown below.
Sleep 120 min.
Sleep Off Sleep 30 min.
The SLEEP indicator blinks while setting the amount
of time for the sleep timer.
Sleep 120min.
If the sleep timer is set, the SLEEP indicator on the
front display lights up.
Note
• To disable the sleep timer, select "Sleep Off".
• The sleep timer setting can also be canceled by pressing
A (power) to set this unit to standby mode.
SPEAKERS
A
(power)
B
SLEEP
SLEEP
BLUETOOTH
OPT 2 CD
LINE 2 LINE 3
Sleep 90 min.
Sleep 60 min.
A
SLEEP
VOL.