Table of Contents
Advertisement
PV Series
Step 15.
To resume operation, follow the instructions located on the lighting
instruction label or the lighting instructions located in the installation and
operation manual.
Pressure Switch Testing
Step 1.
Position power switch on gas
control to the "OFF" position.
Step 2.
Remove the three screws (Phillips screw driver) from control access cover
on blower assembly and remove cover (see photo 1).
Step 3.
Carefully remove pressure switch from blower housing (see photo 2).
20
20
WARNING
115 volt potential exposure. Use
caution to avoid personal injury.
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
