Sharp PN-L703WA Operation Manual page 13

7. Audio 1 input terminal
8. Audio 2 input terminal
• Use an audio cable without resistance.
• Set the audio input terminal to be used in each input
mode in AUDIO SELECT on the SETUP menu.
9. DisplayPort output terminal
• The screen displayed on the monitor and the audio output
from the monitor can be output to an external device.
• Use a commercially available DisplayPort cable
(conforming to the DisplayPort standard).
• Outputting HDCP-encrypted video requires an external
device which supports HDCP.
10. Audio output terminal
• The output sound varies depending on the input mode.
• The volume of the output sound can be fixed by setting
AUDIO OUTPUT of AUDIO OPTION on the SETUP
menu.
• It is not possible to control the sound output from the
audio output terminals with the AUDIO menu.
11. Touch pen adapter port
• Connect the touch pen adapter (supplied). (See page 20.)
12. USB 1 port (for touch panel)
• To use the touch panel with the computer connected to
the bottom, connect the touch panel to the computer with
the USB cable.
(Factory setting. Can be changed in TOUCH INPUT
SELECT on the SETUP menu.)
13. USB 2 port (for touch panel)
• To use the touch panel with the computer connected to
the side, connect to the computer with the USB cable.
(Factory setting. Can be changed in TOUCH INPUT
SELECT in the SETUP menu.)
14. RS-232C input terminal
• The monitor can be connected to a computer using the
RS-232C conversion cable (supplied) and a commercially
available RS-232 straight cable to control the monitor
from the computer.
15. LAN terminal
• You can control the monitor from a computer on a network
by connecting a commercially available LAN cable
between this terminal and a network.
Connecting Peripheral Equipment
16. External speaker terminals
• To use external speakers, set SPEAKER SELECT to
EXTERNAL in AUDIO OPTION on the SETUP menu.
• Be sure to use external speakers with an impedance of 6 Ω
or greater and a rated input of at least 10 W.
1
1. While pushing the tab, insert the tip of the cable.
2. Release the tab.
TIPS
• Be sure to connect the + and - terminals and the left and
right speakers properly.
• Avoid short circuiting the + and - terminals.
• When SPEAKER SELECT is set to EXTERNAL, the
internal speakers are disabled.
Wireless controller terminals
For information on the wireless controller, see the Wireless
Controller Operation Manual.
17. USB port
• Connect the USB flash drive that will be used with the
wireless controller.
18. LAN terminal
• A commercially available LAN cable can be used to
connect the wireless controller to the network while in
use.
19. Wireless adapter port
• Connect the wireless adapter (supplied). (See page 17.)
2
13
E