Advertisement
About the water filtration system.
Filter Cartridge Installation or Replacement
CAUTION:
filtration system.
Close the water supply saddle valve to the filter. (See the Installation
1
Instructions for saddle valve location.) Press the vent valve on the top
of the filter I head to relieve the pressure in the system, or open the
filtered water faucet.
Remove the sump, using the sump wrench tool provided, from the
2
filter head, by rotating the sump as shown in the below illustration.
Be careful, the sump may be full of water. Be sure to keep the large
o-ring seal.
Turn sump wrench tool
provided, clockwise
If you are replacing a filter cartridge, remove and discard the used filter
3
cartridge.
Be sure the inside of the sump is clean. Thoroughly wash the inside of
4
the sump with hot, soapy water and rinse.
Remove the wrapper from the new filter cartridge and insert the filter
5
cartridge in the sump. Some cartridges fit either way, while others fit
only one way. Observe markings on the cartridge.
NOTE: The water filtration system uses two different types of filter cartridges.
Be sure to install them correctly.
The sediment/taste and odor filter (FXUS) should always be placed in the
filter I sump.
8
Never remove the sumps when water pressure is in the water
Vent valve
Cartridge
O-ring seal
TURN SUMP
TO REMOVE
Filter II
Filter I
Bracket
Head
Sump
TURN SUMP
TO INSTALL
Advertisement
