Inserting An Optical Disc; Tray Load; Slot Load - HP 2000-210 Reference Manual

Inserting an optical disc

Tray load

1. Turn on the computer.
2. Press the release button (1) on the drive bezel to release the disc tray.
3. Pull out the tray (2).
4. Hold the disc by the edges to avoid touching the flat surfaces and position the disc label-side up
over the tray spindle.
NOTE:
5. Gently press the disc (3) down onto the tray spindle until the disc snaps into place.
6. Close the disc tray.
NOTE: After you insert a disc, a short pause is normal. If you have not selected a media player, an
AutoPlay dialog box opens. It prompts you to select how you want to use the media content.

Slot load

CAUTION:
the optical drive.
1. Turn on the computer.
2. Hold the disc by the edges to avoid touching the flat surfaces and position the disc label-side up.
48 Chapter 6 Drives
If the tray is not fully accessible, tilt the disc carefully to position it over the spindle.
Do not insert 8-cm optical discs into a slot load optical drive. It may cause damage to