Connecting To A Local Area Network (Lan) (Select Models Only) - HP 2000-210 Reference Manual

7. Select a country or region from the Country/region list. (If you select a country or region that is
not supported by the modem, the country/region selection for USA or UK is displayed.)
8. Enter the area code, a carrier code (if necessary), and the number for an outside line (if
necessary).
9. Next to Dial using, click Tone or Pulse.
10. Click OK to save your new location setting. The Phone and Modem Options window opens.
11. Do one of the following:
●
To set your new location setting as the current location, click OK.
●
To select another location setting as the current location setting, select your preference
from the settings in the Location list, and then click OK.
NOTE:
own country or region as well as in other countries or regions. For example, you could add a
setting named "Work" that includes dialing rules for accessing an outside line.

Connecting to a local area network (LAN) (select models only)

Connecting to a local area network (LAN) requires an 8-pin, RJ-45 network cable (purchased
separately). If the network cable contains noise suppression circuitry (1), which prevents interference
from TV and radio reception, orient the circuitry end of the cable (2) toward the computer.
To connect the network cable:
1. Plug the network cable into the network jack (1) on the computer.
You can use the preceding procedure to add location settings for places within your
Connecting to a wired network 13