Table of Contents
Advertisement
Replacing the Top Cover
To replace the top cover, follow these steps:
1. Replace the desktop expansion base top cover by aligning its
two front corners with the two front corners of the expansion
base. Then push down in the center of the top cover assembly
until it is seated.
2. Replace the three screws that secure the top cover to the
expansion base.
Replacing the Screws on the Top Cover
3. Replace the alignment tray of the expansion base by sliding it
straight back until it clicks into place.
Replacing the Rear Panel
To replace the rear panel, follow these steps:
1. Reposition the expansion base so that its rear panel is
facing you.
2. Replace the rear panel by inserting the tabs on the top of the
rear panel into the slots in the top cover. When the tabs are in
the slots, pivot the bottom of the rear panel downward until it
is seated.
3. Secure the rear panel by moving the rear panel release latch
right to the closed position.
4. Reconnect the power cord and all external equipment cables to
the expansion base.
10-14 Installing and Removing a Half-Height Bay Device
Advertisement
Table of Contents
