Table of Contents
Advertisement
Manually Configuring your Modem-Router
Click Add or Edit to
display the following page
and add a new static route
to the list.
Parameter
Description
Index
Displays the number of the route.
Network
Enter the IP address of the remote computer for
Address
which to set a static route.
Subnet Mask
Enter the subnet mask of the remote network for
which to set a static route.
Gateway
Enter the WAN IP address of the gateway to the
remote network.
30
Manually Configuring your Modem-Router
RIP Parameter
The device supports
Routing Information
Protocol (RIP) v1 and v2
to dynamically exchange
routing information with
adjacent Modem-Routers.
Parameter
Description
RIP mode
Globally enables or disables RIP.
Auto summary
If Auto summary is disabled, then RIP packets will
include sub-network information from all sub¬net
works connected to the ADSL Modem-Router.
If enabled, this sub-network information will be
summarized to one piece of information covering
all sub-networks.
Interface
The WAN interface to be configured.
Operation
Disable: RIP disabled on this interface.
Mode
Enable: RIP enabled on this interface.
Silent: Listens for route broadcasts and updates
its route table. It does not participate in sending
route broadcasts.
Version
Sets the RIP version to use on this interface.
Poison Reverse
A method for preventing loops that would cause
endless retransmission of data traffic.
31
1
2
3
4
5
6
7
Advertisement
Table of Contents
