Table of Contents
Advertisement
O
PERATION
NOTE
The blade cover is used for transportation and storage. Remove
blade cover before using the unit.
NOTE
Refer to the Hedge Clipper Safety Manual for additional proper and
safe Trimming Techniques.
STARTING COLD ENGINE
1. Stop Switch
Move stop switch (A) away from the STOP position.
2. Choke
Move choke (B) to the Cold Start (CLOSED) position.
3. Primer
Pump primer bulb (C) until fuel is visible and flows freely in the clear
fuel tank return line. Pump bulb an additional 4 or 5 times.
4. Recoil Starter
Lay the unit on a flat, clear area. Grip the front handle securely with
one hand, and pull the recoil starter handle (D) until engine fires (or 5
pulls maximum).
5. Choke
After engine fires or 5 pulls, move choke (B) to the RUN (OPEN)
position. Restart engine if necessary and allow unit to warm up at
idle for several minutes.
WARNING
The blades should not move at idle. If blades move, readjust
carburetor according to "Carburetor Adjustment" instructions in
this manual or see your ECHO Dealer, otherwise serious personal
injury may result.
NOTE
If engine does not start with choke in "Run" position after 5 pulls,
repeat instructions.
6. Throttle Trigger
After engine warm-up, grip the handle to depress the throttle trigger
lockout, and gradually depress throttle trigger to increase engine
RPM to operating speed.
DANGER
H
C
EDGE
LIPPER
O
'
M
PERATOR
S
ANUAL
A
B
C
D
B
11
Advertisement
Table of Contents
