Installing Air Filter - Grizzly T33150 Owner's Manual

Installing Air Filter

The Models T33150 and T33151 can both be
hung from the ceiling with the included eye bolts.
However, the T33150 also includes rubber feet, so
the machine can be placed on a bench or table for
easy access.
If hanging the air filter from the ceiling, it is very
important that the machine be supported properly.
Please follow these guidelines when planning
where to mount the air filter.
• The air filter can only be hung from the eye
bolts that screw into the top of the machine.
• Make sure that an electrical outlet with a
properly grounded receptacle is available at
the location you choose.
•
The hanging air filter must be supported by
wood joists. These joists should be capable
of supporting at least 100 lbs each. DO NOT
attach the hanging air filter to only sheet rock,
press board or paneling. These materials
cannot support the filter, and it may fall.
• Avoid hitting your head on the hanging air
filter. Make sure there is enough clearance
between the unit and the ground, especially
important in a basement. If possible, posi-
tion the air filter in an area that has little
foot traffic but still offers easy access to the
control panel and filters.
Model T33150/T33151 (Mfd. Since 03/22)
Workbench Installation (T33150)
The air filter can be used as a portable air filtration
system by installing the rubber feet and placing
the unit on a workbench or a table.
This machine and its
components
heavy. Get lifting help or
use power lifting equip-
ment such as a forklift to
move heavy items.
To install machine on workbench:
1. With help from an assistant, carefully flip air
filter on its side.
2. Thread (4) rubber feet into holes on bottom of
machine (see Figure 13).
Figure 13. Rubber feet installed.
3.
Place machine on workbench in location that
conforms to recommendations under Site
Planning on Page 18.
are very
-19-