Checking The Send Status; Cancelling Memory Transmission (While Originals Are Being Scanned); Cancelling Memory Transmission (During Communication) - Kyocera Triumph-Adler P-3527w Operation Manual

Sending Faxes > Basic transmission procedure

Checking the Send Status

1
2
Cancelling Memory Transmission (while originals are being
scanned)
1

Cancelling Memory Transmission (during communication)

NOTE
Even if transmission is canceled, there is a possibility that pages scanned prior to cancelation were sent to the
receiving party. Check with the receiving party to see if pages were accidentally sent.
1
2
Select the [Status/Job Cancel] key.
Display the send job status screen.
Select [Send Job Status].
The list of accepted time, destination, and status are displayed for each job.
Select the [Stop] key.
During memory transmission, to cancel scanning while originals are being scanned, select the
[Stop] key on the operation panel, or select [Cancel] on the touch panel.
Scanning of originals is canceled, and the originals are ejected. When originals remain in the
document processor, take them out from the original output table.
Select the [Status/Job Cancel] key.
Canceling Transmission.
1
Select [Send Job Status].
2
Select the transmission job that you want to cancel and select [Cancel] > [Yes]
Cancel the transmission.
NOTE
In some cases, transmission may take place even if the [Stop] key or [Cancel] is selected.
3-4