Kyocera Triumph-Adler P-4025w Operation Manual page 168

Troubleshooting > Error Code List
Error Code
E01600
E01700 - E01720
E01721
E01800 -E01820
E01821
E03000
U03000
E03200
U03200
E03300
U03300
E03400
U03400
E03500
U03500
E03600
U03600
E03700
U03700
E04000
U04000
E04100
U04100
E04200
U04200
E04300
U04300
E04400
U04400
Communication error occurred during reception of high-speed transmission. Ask the sender to reduce
the transmission speed and send again.
NOTE
If the communication error occurs frequently, change the default setting of RX Start Speed in System
Menu.
Communication error occurred during high-speed transmission. Send again.
If you still have trouble, reduce TX Start Speed and send again.
NOTE
If the communication error occurs frequently, change the default setting of TX Start Speed in System
Menu.
Communication error occurred during high-speed transmission. Designated transmission speed may
not be available for the recipient machine.
Reduce the transmission start speed and send again.
Communication error occurred during reception of high-speed transmission. Ask the sender to reduce
the transmission speed and send again or reduce the RX Start Speed in System Menu.
Communication error occurred during reception of high-speed transmission. Designated transmission
speed may not be available for this machine. Ask the sender to reduce the transmission speed and
send again or reduce the RX Start Speed in System Menu.
During polling reception, a fax could not be received because no originals were set in the other party's
fax machine. Check with the other party.
Sub address bulletin board reception was attempted and the other party's machine is an our brand
model, but the specified sub address box contained no data. Check with the other party.
An error occurred due to either 1 or 2 below.
Check with the other party.
1 The other party's machine is an our-brand model and transmission restrictions were found set by
the other party during polling reception. Communication was interrupted because the password was
incorrect.
2 The other party's machine is an our-brand model and transmission restrictions were found set by
the other party during sub address bulletin board reception.
Communication was interrupted because the password was incorrect.
Polling reception was interrupted because the Polling ID entered by the other party did not match the
Local FAX ID on the receiving machine. Check with the other party.
Sub address bulletin board reception was attempted and the other party's machine is an our brand
model, but the specified sub address box was not registered on the other party's machine.
Check with the recipient.
The other party's machine is an our-brand model and sub address bulletin board reception was
interrupted because the specified sub address password was incorrect. Check with the other party.
Sub address bulletin board reception was attempted but the other party's machine either does not
have a sub address bulletin board communication function or there were no originals in any of the
originals transfer boxes (sub address boxes).
Specified sub address box is not registered in our brand recipient machine, or the sub address does
not match.
Recipient machine is not equipped with a sub address box function, or the sub address does not
match.
Encrypted transmission was canceled because the specified box is not registered.
Encrypted transmission was canceled because the recipient fax is not equipped with an encrypted
communication function.
Encrypted transmission was canceled because the encryption key does not match.
Possible Cause/Action
9-7