Section 4: Operations; Operation Safety; Cutting - Grizzly H3118 Owner's Manual

SECTION 4: OPERATIONS

Operation Safety

To reduce the risk of
serious injury when using
this machine, read and
understand
manual before beginning
any operations.
Damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Loose hair, clothing, or
jewelry could get caught
in machinery and cause
serious personal injury.
Keep these items away
from moving parts at all
times to reduce this risk.
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC-
OMMEND that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. Regardless of the con-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
-14-
To make a cut:
1.
2.
this entire
3.
4.
5.
6.

Cutting

Using a marking pencil, mark the cut line on
a piece of tile.
Unlock the rip fence (Figure 9) and slide it to
the edge of the table.
Figure 9. Rip fence locking lever.
Line up the cut line on the tile with the saw
blade.
Adjust the rip fence against the edge of the
tile and lock the rip fence into position.
Turn the saw ON and allow it to reach full
speed. Be sure the blade runs smoothly. The
blade should also be wet from the water tray
below the saw.
Keeping your fingers out of the cutting path,
slowly slide the tile into the moving blade.
Note: DO NOT feed the tile into the blade
too fast. If the motor sounds like it is slowing
down during the cut, you are feeding the tile
too fast. Slow down the feed rate immedi-
ately.
H3118 Tile Saw