Always use a low spindle speed when
machining non-cylindrical or off-center
workpieces to avoid ejecting the workpiece
from the holding device at a high rate of
speed. Failure to heed this warning could
lead to serious personal injury or property
damage.
Using the Faceplate
To mount a workpiece on the faceplate:
1.
2.
3.
Figure 30
Note: Take into account the rotation and
cutting forces that will be applied to the
workpiece when clamping it to the faceplate.
Figure 30.
Centers
Figure 31.
Tailstock
Installing a Sleeve and Center into
the Spindle
1.
2.
Figure 31
Page 27