Battery Recharging - VTech MY FIRST KidiSmartwatch Instruction Manual

position (o), the unit will not function and the battery will not charge.
Only move the switch to the Off position when the watch will not be
used for an extended period of time.
Note: It is not necessary to turn the watch off in daily use. Once the
Master Power Switch is Off, the watch will stop functioning. After it is
turned On again, the time and date will have to be reset.

BATTERY RECHARGING

Note: Adult operation required.
The watch should be fully charged before first use. To charge the
My First KidiSmartwatch, connect the watch to a computer using
the included Micro-USB Cable (Please refer to the CHARGING
GUIDELINES section of this guide). To do so correctly, please follow
these steps:
• Make sure that the Master Power Switch is set to the On position
before charging.
• Pull open the rubber cover of the Micro-USB Port on the side of the
watch.
• Insert the Micro-USB Cable (small end) into the Micro-USB Port on
the watch.
• Insert the large end of the Micro-USB Cable into a USB port on your
computer or USB port (Output DC 5V 1A) with Class II
symbol.
• Once the connection is successful, you will see a battery charging
symbol appear on the watch screen.
• Check the charging progress regularly throughout recharging.
• When the battery is fully charged, the fully
charged battery icon will appear. Then the
screen will automatically turn off. You may then
disconnect your fully charged watch from the
computer.
Note: It will take approximately 3.5 hours to fully
charge the battery. The actual charging time
depends on the charging current, the remaining charge in the battery
prior to recharging, and the ambient temperature. The optimum
ambient temperature is
32°F - 104°F (0°C to 40°C).
or III
6