Canon Super G3 FAX board-AL1 Service Manual page 24

5
Service Mode Service Mode > Setting of Bit Switch (SSSW) > Bit Switch Composition > SSSW-SW05
■ SSSW-SW05
● Functional Construction
Bit Function
0 not used
1 Conversion from mm to inch (text mode)
2 Conversion from mm to inch (text/photo mode)
3 end DIS signal bits 33 and over
4 Recording paper length availability declared in DIS signal
5 not used
6 not used
7 not used
Detailed Discussions of Bit 1
Use it to enable/disable millimeter/inch conversion in sub scanning direction for images read
in text mode.
Detailed Discussions of Bit 2
Use it to enable/disable millimeter/inch conversion in sub scanning direction for images read
in text/photo mode while bit 1 is set to '1'.
Detailed Discussions of Bit 3
Use it to enable/disable transmission of bit 33 and thereafter (DIS signal).
Caution:
If 'prohibit' is selected, the Super Fine reception function or Memory Box function cannot
be used for communications from non-Canon machines.
Detailed Discussions of Bit 4
Use it to enable/disable declaration of the use of cut sheets (DIS signal).
For reception of an extra-long original, select 'A4/B4 size' if division is to be by the other party.
MEMO:
Some machines are not designed to divide extra-long originals.
5 Service Mode > Setting of Bit Switch (SSSW) > Bit Switch Composition > SSSW-SW05 Service Mode
1 0
- -
convert do not convert
convert do not convert
prohibit do not prohibit
A4/B4 size any size
- -
- -
- -
T-5-6
5-8
5-8