Grizzly G0620 Supplement Manual page 22

3.
Press the F/ENTER
"Select" appears on the display (Figure 40)
with "ORG" and a number next to it, prompt-
ing you to select which ORG to program.
Note: When programming "ORG 0," put the
digital stop block stopper in the home origin
block (the closest one to the blade) and put
the second stop block stopper in the ori-
gin block closest to the home origin block.
Measure the distance from the usable face
of the digital stop block to the usable face
of the second stop block, and program that
distance into the controller. When program-
ming "ORG 1," move the second stop block to
the origin block near the fence extension and
repeat.
��� ������� �������
���
Figure 40. ORG select screen.
4.
Use the arrow keys to select which ORG to
program, then press the F/ENTER
The display changes to an entry screen with
a flashing "0", as shown in Figure 41. (Due
to resolution settings, the number of zeros
displayed may not match the figure exactly.)
��������
��� ������� �������
���
Figure 41. Controller ready to enter a value for
ORG 0.
-20-
key.
�
�����
�
�����
key.
�
�����
�
�����
5.
Use the left and right arrows on the ABS/REL
and mm/inch
�������
you want to modify.
Modify the digits by pressing the CLR/SET
key when the desired digit is blinking.
���
���
The smaller 0 at the far left of the number rep-
resents a positive value, but can be modified
to a negative value if desired by pressing the
CLR/SET key when it is blinking.
���
���
6.
Press the F/ENTER
rent number in the controller.
The display will go back to the "Select"
screen. From this screen, you can enter addi-
tional cutoff values by repeating Steps 4-5.
7. To exit the "Select" screen, press the CLR/
SET key.
���
���
The display will go back to the "Offsets"
screen.
8.
To exit the "Offsets" screen, press the CLR/
SET key.
���
���
Activating Stored Offsets
1.
Press and hold the F/ENTER
press the ABS/REL
the ORG numbers.
The offset value is automatically applied to
the current value displayed when the related
ORG number is selected.
G0620 Main Control Panel
keys to select the digit
key to save the cur-
�
�����
key, then
�
�����
key to cycle through