Combining Adjustment Entries - Grizzly G0620 Supplement Manual

Combining
Adjustment Entries
The controller has the ability to combine numeri-
cal input entries of the blade height, blade tilt, and
rip fence without closing the input cycle after each
entry. This is typically the most efficient way to set
up a new cut.
To enter multiple entries, follow the same steps
for numerical adjustments with each control, but
wait to press the Start
control input has been entered.
Example: If you want to set up a cut with a blade
height of 2.25", a blade tilt of 22.5°, and a cut-
ting width of 18.25", you would do the following
steps:
1.
Press the blade height
The indicator light on the blade height
shines to show that the control panel is ready
to accept input.
2. Use the number keys to enter the blade
height (Figure 12).
� ���
�
�
�� ��
Figure 12. First entry.
3.
Press the blade tilt
The indicator light on the blade tilt
shines to show that the control panel is ready
to accept input. The indicator light on the
blade height key no longer shines, but the
numbers previously entered still flash.
G0620 Main Control Panel
key until after the last
key.
key
key.
key
4.
Use the number keys to enter in the blade
angle (Figure 13).
����
����
�
����
Figure 13. Second entry.
5.
Press the cutting width
The indicator light on the cutting width
key shines to show that the control panel is
ready to accept input. The indicator light on
the blade tilt key no longer shines, but
both numbers previously entered continue to
flash.
6. Use the number keys to enter the cutting
width (Figure 14).
����
����
�����
����
Figure 14. Third entry.
7.
Press the Start
All components will move to their respective
positions and the indicator light on the cutting
width key will stop shining.
key.
key.
-9-