Rip Fence Thickness Calibration - Grizzly G0620 Supplement Manual

Rip Fence Thickness
Calibration
The rip fence can fit on the base in two positions,
as shown in Figures 27 and 28. When the fence
is changed from one position to another, the con-
trol panel automatically adjusts the dimensions
shown on the display so the cutting width remains
accurate. The control panel recognizes the fence
positions as A and B, as shown below.
�
Figure 27. Fence position A.
�
Figure 28. Fence position B.
Besides ensuring that the standard fence dimen-
sions are calibrated correctly. The calibration
function can also be used if a sacrificial fence is
attached to the standard rip fence.
G0620 Main Control Panel
To calibrate the rip fence thickness:
1. Turn the control panel OFF.
2. Push and hold the blade width
keys, then turn ON the control panel. The
display will show A and B dimensions, as
shown in Figure 29.
� � �����
����
Figure 29. Rip fence calibration mode.
3. Press the clear key
dimensions of your fence with the number
keys.
4.
Type in a new dimension in the A line or
press the minus key to activate the B dimen-
sion.
5. After entering the new dimension, press and
hold the input confirmation
The numbers you entered are now stored into
the control panel as the correct fence thick-
ness.
and CAL
, then type in the exact
.
-15-