MM/Inch Selection
The controller can display units in millimeters or
inches.
To toggle the display between mm and inches,
�������
press the mm/inch
new unit of measure shows on the control panel.
���������
���
������� �������
���
Figure 31. Pressing mm/inch key to toggle the
displayed unit of measure.
Checking Battery
To check the remaining battery charge:
1.
Press and hold the F/ENTER
sign will appear as this key is held down),
then press and release the mm/inch
The controller displays the remaining charge
left in the battery, as shown in Figure 32.
���
������� �������
���
Figure 32. Current battery charge displayed.
The display will automatically exit out of the
battery charge screen after two seconds.
G0620 Main Control Panel
key (Figure 31) until the
�
Press and
Release
�����
key (the
�
�����
�������
key.
�����
�
�����
Changing Resolution
The display can be adjusted to show a resolu-
tion or accuracy from one to four decimal places,
depending on which unit of measure is selected.
To change the resolution:
1.
Press and hold the F/ENTER
sign will appear as this key is held down),
then press and release the mm/inch
The controller displays the remaining power
left in the battery, as shown in Figure 32.
2.
At the battery charge display screen, press
the CLR/SET
key and the F/ENTER
���
���
key at the same time.
The controller displays the resolution, as
shown in Figure 33.
���
������� �������
���
Figure 33. Resolution displayed to two decimal
places.
3.
Use the left and right arrows on the ABS/REL
and mm/inch
�������
resolution.
4.
Press the F/ENTER
key (the
�
�����
�������
key.
�
�����
�
�����
keys to select the desired
key to exit.
�
�����
-17-