Grizzly G0611X Owner's Manual page 24

Tail Thickness
Figure 33 shows the tail thickness.
��������������
Figure 33. Example of tail thickness.
The tail thickness is controlled by adjusting the
tracer pin when it is in the "out" position on the
template bar, as shown in Figure 34.
��������
���
���
��������
����������
Figure 34. Tracer pin positions on template.
To set the tail thickness:
1.
DISCONNECT MACHINE FROM POWER!
2. Draw a small pencil line on the edge of the
vertical workpiece approximately
the side of the workpiece (see Figure 35).
��������
���������
�����������
�
�
��
Figure 35. Pencil line location on vertical
workpiece.
3.
Install the vertical workpiece so the side of
the board closest to the pencil line is facing
out, as shown in Figure 35, and clamp the
workpiece into position against the vertical
fence.
-22-
��
��������
⁄ " from
1
16
�����
������
����
�
4.
Connect the spring to the headstock.
5. Move the headstock just to the right of the
workpiece, and put the tracer pin in the "out"
position on the template.
6. Stand to the right-hand side of the machine,
and look across the table at the cutter rela-
tionship to the vertical workpiece. This view-
ing position will help you align the cutter with
the workpiece during the next step.
Note: Familiarize yourself with the tracer pin
controls shown in Figure 36 if this is the first
time you have adjusted it.
Adjustment
Thumbwheel
Figure 36. Tracer pin controls.
7.
Unlock the tracer pin, and adjust the thumb-
wheel as necessary until the bottom of the
cutter is positioned as shown in Figure 37.
�����������
������������
����������
�������
������������������
���������������
������
Figure 37. Cutter position for setting tail
thickness (as viewed from the side).
8.
Lock the tracer pin.
G0611X Dovetail Machine
Lock
�����
��������
���������
��������������
����������������
����������������
��������������