Table of Contents
Advertisement
Step 3:
Specify Keystone.
For more information about keystone,
see
Correcting
Step 4:
Specify Auto Source.
Select On if you want the projector to
always search for available signals
automatically when the projector is
turned on.
Step 5:
Specify Menu Type.
For more information about menu
types, see
About the OSD
Now you've completed the initial setup.
4. If you are prompted to enter the password, use the arrow keys on the projector or remote control
to enter a six-digit password. See
5. Switch on the connected equipment.
6. The projector starts to search for available input signals. The current input signal being scanned is
displayed on the screen. If the projector does not detect a valid signal, the "No Signal" message
appears. You may press SOURCE on the projector or remote control to select your desired input
signal.
7. If the horizontal frequency of the input source exceeds the range of the projector, the "No Signal"
message is displayed on the screen. It will remain on-screen until you change the horizontal frequency
of the input source to an appropriate one.
keystone.
Menus.
Utilizing the password function
for details.
Operation
17
Advertisement
Table of Contents
