Section 7: Service Adjustments About Service; Aligning Bending Wing - Grizzly G0542 Instruction Manual

This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—
it is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform
any procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
-20-
Aligning Bending
Wing
In order to achieve accurate bends, the top sur-
face of the bending leaf and the attached bend-
ing wing must be flush with the top surface of the
clamp block when the bending leaf is in the down
position (see Figure 27).
Check for proper alignment by examining how the
edges of each component meet each other. Only
perform the instructions below if the top surfaces
of these components are NOT flush with each
other.
Figure 27. Callouts showing where clamp block
and bending wing must be flush.
G0542 48" Pan and Box Brake