Table of Contents
Advertisement
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
About Service
This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—
it is not a substitute for the Grizzly Service
Department.
If any adjustments arise that are not described in
this manual or you are unsure of how to perform
the procedures in this section, then feel free to call
Technical Support at (570) 546-9663.
G0452/G0452P
Inspecting Knives
The height of the knives can be easily and
quickly inspected with the knife setting jig. This
inspection will ensure that the knives are set in
the cutterhead as they should be. Usually this is
done before calibrating the outside table or when
troubleshooting.
To inspect the knives:
1.
DISCONNECT JOINTER FROM POWER!
2.
Remove the cutterhead guard or block it out
of the way.
-44-
3.
Lower the infeed table to the
4.
Place the knife jig on the cutterhead, directly
over a knife, as shown in Figure 66.
Figure 66. Jig positioned over cutterhead knife.
5.
Carefully inspect how the jig touches the
cutterhead and the knife.
— If both outside legs of the jig sit firmly on
the cutterhead and the middle pad just
touches the knife, then that knife is set
correctly. (Repeat this inspection with the
other knives.)
— If the jig does not sit firmly on the cutterhead
and touch the knife edge as described, then
reset that knife. (Repeat this inspection
with the other knives before resetting.)
G0452/G0452P
Setting Knives
Setting the knives correctly is crucial to the proper
operation of the jointer and is very important in
keeping the knives sharp. If one knife is higher
than the others, it will do the majority of the work,
and thus, dull much faster than the others.
The knife jig included with the jointer is designed
to set the knives at the correct height.
Model G0452/P/Z (Mfg. Since 08/12)
⁄
" scale mark.
1
2
Middle
Pad
Hide quick links:
Advertisement
Table of Contents
