Final Check List - Scotsman F1322L Installation And User Manual

Remote low side modular flaked and nugget ice machines
Table of Contents

Advertisement

N0922L, N1322L, F1222L, F1522L
D Series Remote Low Side User Manual

Final Check List

After Connections
1. Wash out the bin. If desired, the interior of the bin
could be sanitized.
2. Locate the ice scoop (if supplied) and have it
available for use when needed.
Final Check List:
1. Is the unit located indoors in a controlled
environment?
2. Is the unit located where it can receive adequate
cooling air?
3. Has the correct electrical power been supplied to
the machine?
4. Have all the water supply connections been
made?
5. Have all the drain connections been made?
6. Has the unit been leveled?
7. Have all unpacking materials and tape been
removed?
8. Is the correct switch bezel installed in the trim
strip?
9. Is the water pressure adequate?
10. Have the drain connections been checked for
leaks?
11. Has the bin interior been wiped clean or sanitized?
12. Have any water filter cartridges been replaced?
13. Have all required kits and adapters been properly
installed?
14. Has the ice machine been properly connected to
the condensing unit or rack?
Control Operation
Use and Operation
Once started, the ice machine will automatically make
ice until the bin or dispenser is full of ice.
When ice level drops, the ice machine will resume
making ice.
Caution: Do not place anything on top of the ice
machine, including the ice scoop. Debris and moisture
from objects on top of the machine can work their way
into the cabinet and cause serious damage. Damage
caused by foreign material is not covered by warranty.
There are four indicator lights at the front of the
machine that provide information on the condition of
the machine.
Indicator Lights:
• Power
• Status
• Water
• De-scale &
Sanitize
Under the door are two switches – On and Off. To
switch the machine OFF, push and release the Off
button. The machine will shut off at the end of the next
cycle.
To switch the machine ON, push and release the
On button. The machine will go through a start up
process and then resume ice making.
October 2014
Page 10
Switch Door

Advertisement

Table of Contents
loading

This manual is also suitable for:

F1222lProdigy plus d seriesN0922lN1322l

Table of Contents