Searching For Digital Terrestrial; Tv Channels Automatically - Grundig 48 VLE 555 BG Manual

speCiAl­settinGs
searching­for­digital­terrestrial­
tv­channels­automatically
1 Open the menu with »menu«.
2 Select the menu item »SOURCE SETUP« with
» « or » « and press »oK« to confirm.
v Λ
– T he »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
or » « and press »oK« to confirm.
Λ
Select the option »Air« with »
» « and press »oK« to confirm.
Λ
Caution:
The antenna power supply (line »Active
7
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
s upplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4 Select the »Active Antenna Power« with »
or » «. Switch on the antenna power supply
Λ
for the antenna with »
5 Select the line »Automatic Channel Search«
with » « or » « and press »oK« to confirm.
v Λ
– T he menu appears.
SOURCE SETUP
AUTOMATIC CHANNEL
Connection Type
Country
Scan Type
Exit
Back
­ - ---------------------------------------------------------------------------------------------------------
v
< >
«, » «, » « or
v
v
< >
« or » « (»On«).
20.09.2010
15:46
SEARCH
Air
U.K.
DTV & ATV
Start Search
6 Select the line »Scan Typ« with »
and set the option »DTV« with »
7 Start the scan with »
– A ll channel and favourites lists will be
d eleted and compiled anew.
note:
After starting the scan, a security query will
7
«
appear. Press »
option »Yes«.
– T he »Reults« menu appears, and the scan
for TV channels begins. Depending on the
number of television channels received,
this can easily take a few minutes.
– T he scan is complete as soon as the
» PROGRAM TABLE« appears.
note:
You can abort the search by pressing
7
»exit«.
8 Press »exit« to end the setting.
«
Automatic­service­update­
If this function is activated, possible changes of
network operators are updated automatically.
The unit must be located in stand-by mode.
1 Open the menu with »menu«.
2 Select the menu item »SOURCE SETUP«
with » « or »
v
confirm.
3 Select the line »Automatic Service Update«
with » « or »
v
4 Select the automatic update with »
(»On«).
5 Press »exit« to end setting.
v
<
« or »
« (red).

« (green) to confirm the

« and press »oK« to
Λ
«.
Λ
<
enGlish
« or » «
Λ
>
«.
>
« or » «
­ 5 3