Hoshizaki KMD-270AWA Service Manual page 54

5) Refit the removed parts in the reverse order of the removal procedure.
Control Box
Note: After replacing the components inside the control box, connect and tie the wires
properly in their correct position. Especially make sure that the harness does not
press the push buttons on the control board.
Control Switch
Service Switch
Fuse
Fuse Holder
Run Capacitor
Start Capacitor
51
Screws
Control Box Cover
Screw
Controller Board
Noise Suppression Capacitor
Push Buttons
Transformer
Starter
Capacitor for Pump Motor
Magnetic Contactor