Amana NTC3500FW0 Use And Care Manual page 8

7.
Connect inlet hoses to washer
Remove inlet cap and attach hot water hose to hot water (right)
inlet valve. Screw coupling by hand until it is snug. Use pliers
to tighten couplings an additional two-thirds turn. Repeat with
cold water (left) inlet valve.
IMPORTANT: To reduce risk of hose failure, replace the hoses
every 5 years. Record hose installation or replacement dates
for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
■
wear, or leaks are found.
8.
Check for leaks
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
If you connect only one water hose, you must cap (supplied)
■
off the remaining water inlet port.
8
Secure Drain Hose
9.
Secure drain hose to laundry tub,
standpipe, or wall
Laundry Tub Standpipe
4.5"
4.5" 4.5"
(114 mm)
(114 mm) (114 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie (provided).
Do not force excess drain hose back into the rear of
■
the washer.
To avoid siphoning, do not seal or put more than 4½"
■
(114 mm) of the drain hose into drainpipe or standpipe.
Install Leveling Feet – Optional
(for permanent installation only)
IMPORTANT: Installation of the leveling feet is permanent.
Once the leveling feet are installed into the base of the washer
they cannot be removed.
10.
Install leveling feet
Front
Lay washer on its back. Push in to snap the large black rubber
foot into the right front corner of the washer base. Repeat to
install the remaining leveling feet on the other 3 corners.
Wall
4.5"
4.5"
(114 mm) (113 mm)
Large
black
rubber
foot