Table of Contents
Advertisement
Disconnect Washer
1.
Remove fill-and-drain hose connector
from faucet
Red water-flow
button
Turn off water faucets and unplug the power cord. Press the
red water-flow button to release water pressure in the hose.
Pull the locking collar down to remove the connector from
the faucet.
2.
Replace fill-and-drain hose on storage
bracket
Pour water out of the faucet connector. Place fill-and-drain
hose on the plastic holder in the back of the washer.
12
Complete Installation Checklist
q
Check electrical requirements. Be sure you have correct
electrical supply and recommended grounding method.
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Check that shipping materials were completely
removed from washer.
q
Check that water faucets are on.
q
Check for leaks around faucets and inlet hoses.
NOTE: If the washer is attached to a faucet equipped
with a spray hose, the constant water pressure may
cause the spray hose to leak. To avoid possible failure,
the spray hose should be disconnected or replaced with
a high-pressure hose.
q
Remove protective film from console and any tape
remaining on washer.
q
Check that washer is plugged into a grounded
3 prong outlet.
q
Dispose of/recycle all packaging materials.
q
Read "Washer Care" in your Use and Care Guide.
q
To test and clean your washer, measure ½ of normal
recommended amount of powdered or liquid detergent
and pour it into washer basket or detergent dispenser
(on some models). Close lid. Select any cycle. Start
washer and allow to complete full cycle.
Advertisement
Table of Contents
