Zoom Submenu - Fluke TiX660 User Manual

TiX620, TiX640, TiX660, TiX1000
Users Manual
High Alarm, Low Alarm
Just as in Interval, a (partial) temperature interval is
defined in the High Alarm and Low Alarm modes, not only
the upper and/or lower limits are defined for the partial
areas at this point. For the Above option, all areas above,
and for the Below option, all areas below the adjustable
temperature limit are displayed. The upper limit for the
Above option corresponds to the upper limit of the set
total range. The lower limit for the Below option
corresponds to the lower limit of the total range.
Continual Blend
®
In all IR Fusion modes, the transparency of the continual
blend area can be selected. The degree of continual
blend (Alpha blending) can be set in the "Blending"
submenu in an infinitely variable manner.
hvh106.jpg
3-8
hvh107.jpg

Zoom Submenu

Depending on the equipment, the thermal imager
supports digital magnification of the infrared image and
the Digital image (visible light image) up to 32-fold. The
setting is made in the "Setting" menu using the "Zoom"
menu item and is applicable to the currently displayed
image in each case (infrared image or visible light image).
A set magnification is indicated as the corresponding
status symbol to the right below the image. If the
image was enlarged digitally, the enlarged section of the
image (initially located in the center of the image) can be
moved. By shortly pushing the joystick Enter button, you
can toggle between the options enlargement (zoom) and
Move. The function active in each case is indicated by
blackened joystick symbols in the upper part of the menu.
The zoom level and the position of the enlarged section of
the image are indicated in the left bottom area of the total
image. After the enlarged section of the image has been
moved from the center of the image, the joystick Enter
button must be pushed longer to center the section of the
image.